Quality
Quality
Badge alignment
We measure the gap from the collar seam and check both sides. A badge sitting off-centre by more than a few millimetres is rejected.
Print edges
Sponsor and number prints are checked for lifted corners, bubbling and colour bleed, especially along the sleeve and hem.
Stitching and seams
Side seams, cuffs and hems are pulled gently. Loose thread or uneven tension means the shirt does not ship.
Label and sizing match
The size on the neck label must match the size you ordered and the measurements on our chart for that product.
Care
Wash inside out at 30°C or cold, with similar colours.
Do not use bleach, fabric softener or a hot tumble dryer cycle. Air dry where possible.
Do not iron directly over badges, sponsor prints or names. Iron the reverse side only.
Turn inside out before washing to protect print edges across seasons.